| Casters - Standard caster assemblies consist of 4 casters mounted on 1/2" plywood casterboard (except removable system) with 1/4" bolts and keepnuts. In turn, the casterboard is mounted with one bolt through each caster, casterboard, and case. | |||
3" Baco soft rubber tread swivel caster. Load rated at 125 lbs. |
3" Baco soft rubber tire non-swivel caster. Load rated at 125 lbs. |
3-1/2" Polyethylene wheel with double ball bearing raceway. Optional lock assembly. Load rated at 250 lbs. |
Heavy duty casters slide in and out of plates permanently mounted to case bottom on 1/2" casterboard with 3/4" run- |
(Optional) This optional fully-recessed key lock provides the most secure locking feature, but will not permit dust or water tight seals. |
(Optional) Padlock Latch is a split-dish latch with padlock loop on top dish. This optional feature will not permit dust or water tight seals. Padlock is not included. | (Optional)  Non-recessed drawbolt latch. Standard when case size will not permit the use of our recessed latches or when Category II construction is preferred. |
(Optional) Non-recessed, spring-loaded, large, rubber grip handle. Standard when case size will not permit the use of our recessed handle or when Category II construction is preferred. |
Internal partitions are constructed of 1/4" or 1/2" AC plywood. 1/4" partitions utilize our custom extruded aluminum F-channel; 1/2" partitions utilize custom extruded aluminum angle and are permanently riveted to exterior case walls. Partitioned tops are fitted with aluminum cap molding. |
Trays are constructed in ATA, Eagle, wood or plastic. Drawers are constructed in ATA, Eagle or wood. (ATA, Eagle and plastic shown) |
|
